You should log in at the ASA prompt, where you willīe prompted to change the enable password.
Rommon will continue to boot disk0: fxos-k8-fp2k-lfbff.2.3.1.132.SSBĭuring bootup, the system prompts you to log into FXOS and to set the admin password although you will not cause any harmīy logging in, you should continue to wait until it boots up the ASA. Image size 27 inode num 16, bks cnt 1 blk size 8*512 Please type 'ERASE' to confirm the operation or any other value to cancel: ERASE
This operation cannot be undone after booting the application image.Īre you sure you would like to continue ? yes/no : yes Warning: All configuration will be permanently lost with this operationĪnd application will be initialized to default configuration. If you are not prompted to boot the image, enter the boot command. You will be prompted multiple times to confirm that you want to erase your configuration, and then boot up the image. To verify the ROMMON version, enter show info. Platform FPR-2130 with 32768 MBytes of main memoryįor ROMMON version 1.0.04, use the password_reset command this command was changed to factory-reset in later versions. Press Esc during the bootup when prompted to reach the ROMMON prompt. ProcedureĬonnect to the console port, and power on the Firepower device.
You must have console access for this procedure. If you know the password, and want to restore the factory default configurationįrom within FXOS, see Restore the Factory Default Configuration. This procedure also resets the ASA configuration. The admin password is reset to the default Admin123. Restore the FXOS configuration to the factory default using ROMMON. If you cannot log into FXOS (either because you forgot the password, or the SSD disk1 file system was corrupted), you can The procedures in this chapter note Appliance Mode and Platform Mode differences. When you log into FXOS, use the admin user and the ASA enable password that you set previously.įirepower 2100 Platform mode allows FXOS configuration of chassis functions at all times. Only the management interface canīe configured in failsafe mode.
Interface with an IP address, DNS, and NTP so you can download and install the ASA image. This mode, FXOS allows minimal configuration to allow diagnosis and recovery of the system. If the Firepower 1100 or Firepower 2100 in Appliance Mode fails to boot into ASA, it will boot into FXOS failsafe mode. Restore the Factory Default Configuration.SSD File System Corruption (Firepower 2100).This entry was posted in Tech Support, Uncategorized on Jby curreri.This section includes procedures to troubleshoot bootup issues and perform password recovery. This doesn’t seem to reset the Enable password, so you’ll have to use that to login.Close the ASDM without saving, renew you DHCP lease and log in using the ASDM to the new address.This is because the ASDM is trying to manage the device using the old IP. After a few minutes, I got a status message with an ERROR.You can use any non-routable IP, such as .1 where x is 1-254. This is useful if you ever have to put another firewall device behind this device as some consumer grade devices make it a pain to change the internal subnet. This will change the subnet of devices behind the firewall.
If you can’t use the ASDM, I have also have a write up for Resetting the Cisco asa 5505 Using the Console. If you have been mucking around in your Cisco ASA5505 and want to return to factory defaults using the ASDM management software, it’s pretty easy.